Instructions for Operation:
To set this fixture to auto mode, simply set the dip switches on the rear of the unit to show dip switch #9 and #10 in the on/up position. This will allow the laser to scroll through all of its patterns automatically.
To set this fixture to sound active mode you must set the dip switches on the rear of the unit to show dip switch #10 on/up only. This will let the laser change patterns to sound. There is a sensitivity knob for the internal mic on the rear of the unit. In this mode, the laser will turn off after a few seconds if there is no sound of the mic sensitivity is set to low.
Set the fixture's address by using the dip switches on the rear of the unit. This unit will identify a DMX signal and know automatically the your are using a DMX signal.
Channel #1 Controls the mode: (this laser must be set to DMX mode on this channel for this lasers effect to work).
0-63 laser off
64-127 Sound active mode
128-191 Auto mode
192-255 DMX mode
Channel #2 Controls the color selection:
2-31 Red laser only
32-63 Green laser only
64-95 Red and green laser
96-159 Changes from red and/or green or just green automatically
160-219 Changes from red to green automatically
220-239 Changes from red and/or green or just green to sound
240-255 Changes from red to green to sound
Channel #3 Controls the strobing effect
0-19 Strobe off
20-239 Strobing from slow-fast
240-255 Sound active strobing
Channel#4 Controls the spinning direction
0-10 No spin
11-60 Spins clockwise
61-80 Spins clockwise and will pause and then continue to rotate automatically
81-100 Spins clockwise and will stop and start to sound
101-160 Spins counter clockwise
161-180 Spins counter clockwise and will pause and then continue to rotate automatically
181-200 Spins counter clockwise and will stop and start to sound
201-255 Changes rotation direction automatically
Channel #5 Controls spin speed
0-255 Spin speed from slow-fast
Set the master fixture to any sound active or auto mode setting. Connect the slave unit using a DMX cable. On the slave unit set dip switch #10 to the ON position. The slave unit then will do the same thing as the master fixture.
|Includes black power cord.|
Click Here To Purchase