|
|
.
.
.
|
|
Instructions for operation: |
 |
| Fill the 1.5 liter tank with standard (water based) fog
fluid. There is a tube that leads from the top of the tank into the
machine (make sure it's suction end rests at the bottom of the fluid
tank). Flip the power switch on the rear of the unit. The switch lights
up red and begins the initial warm up time of about 3 minutes. The 16'
wired controller plugs into the 5 pin input on the rear of the unit.
Adjust the vent in the front of the unit to disperse fog straight out
along the ground or adjust it up to spray fog into the air. The controller consists of 3 buttons marked differently with led indicators above each button. The buttons control the modes and 3 knobs above the buttons control the features in each mode. |
 |
| Manual
Mode The right button is the manual fog button. The manual button has the green light above it to let you know when the fogger is ready to dispense fog (after each complete burst the green light will go off until the fogger has reheated). You cannot control the output in manual mode. Continuous Mode The middle button is the continuous fog button. In this mode, when the fogger has reached it's ready temperature, the it will automatically start blowing fog. The knob above marked "output" controls the amount of fog that it dispenses. All the way to the left is none and turn clockwise to desired output. Always start with the volume knob fully clockwise and gradually turn the knob counter-clockwise because the fog decreases to zero slightly before the knob reaches full off (full counter clockwise). |
 |
| Timer Mode The button marked "Timer" lets you set the fogger to to dispense fog in certain set intervals. Use the knob marked "Interval" to adjust time between blasts. The interval knob goes from 10 seconds to 200 seconds. Ten seconds is all the way to the left, turn clockwise to increase the time between blasts. Use the output knob to set the output to desired volume. The Duration knob controls how long the blast will go on after the fogger has started blowing fog out. Turn the knob clockwise for the longest blast, turn it counter clockwise to shorten the length of time the fogger will dispense fog. |
 |
| DMX Mode After connecting your fogger to your DMX controller using a DMX cable, set the dip switches according to there location in your DMX chain. This fogger is a 1 channel DMX fixture so the 1st slider controls the volume of fog that it will dispense. Slide the slider all the way up for the most output. |
 |
| Includes black power cord. |  |
