Stage Ape Lighting Stage Ape Lighting



.

.

.


Home

stage ape lighting
stage ape

stage ape

Read Our Warranty
and Store Policies.

Click Here!
stage ape
stage apeThe Ape RBG Panel... stage ape
LED Flat panel with RGB color mixing and strobing, 192 5mm LEDs (64 red, 64 green, 64 blue). ...

This LED panel puts out 2,050 LUX at 1 meter. (A standard PAR 38 can with a 120 watt soft white bulb puts out 1,037 Lux at 1 meter).

Very Low power consumption, Current draw: 30W. LEDs 100,000hr,  color temp >6000K, 

Built-in sound activated and auto programs, master/slave or DMX.

5 channel DMX-512 (Your DMX controller must have a negative polarity switch to run this fixture),

Adjustable flash and speed rate in stand-alone modes, Built-in automated programs via built in mic.

Size: 14.0" x 9.50" x 3"   Weight: 5.0 lb. Fuse: 2 amp short.
PANEL192RGB
stage apeClick Here To Purchase stage ape

Lux Readings at 1 meter:


Red                262
Green            553
Blue               680
All On         2,050

PANEL192RGB

Instructions for STAND ALONE operation:

Press the menu button until one of these appear on the LED screen ( PR##,b,G or r ). Use the up and down buttons to reach the desired effect. Make sure to press enter to active the setting.

PR01 puts the fixture into sound active mode 1
PR02 puts the fixture into sound active mode 2
PR03 puts the fixture into sound active mode 3
PR04 puts the fixture into auto mode 1 (speed can be adjusted see speed adjustment section)
PR05 puts the fixture into auto mode 2 (speed can be adjusted see speed adjustment section)
PR06 puts the fixture into auto mode 3 (speed can be adjusted see speed adjustment section)
PR07 puts the fixture into auto mode 4 (speed can be adjusted see speed adjustment section)
PR08 puts the fixture into auto mode 5 (speed can be adjusted see speed adjustment section)

PANEL192RGB

Speed Adjustment:

Set the fixture to any auto mode setting. Press the menu button until sp## shows up on the display. Use the up and down buttons to select the speed SP01 - SP30 (slow - fast) and then press enter to active.

Color Mixing With Out a Controller:

To color mix and get solid colors with this fixture you must adjust each color individually to your desired level. Press the menu button until one of these appear on the LED screen ( PR##,b,G or r ) and then press enter. Use the up and down buttons until you see r,G or b on the display. Use the up and down buttons to bring each color to your desired brightness from 0 to 255 and then press enter. Make sure speed is set to 1 (see speed adjustment section).

 

PANEL192RGB

DMX Mode

Press the menu button until A### show up on the display. Use the up and down buttons to set the fixture to it's correct address and then press enter. The fixture must be connected to the control using DMX cable.



Channel 1 controls the fixtures strobing function
Channel 2 controls the red LED's
Channel 3 controls the green LED's
Channel 4 controls the blue LED's
Channel 5 controls the fixtures pre set colors

How to use this light with the American DJ MyDMX software

PANEL192RGB

For MASTER / SLAVE Mode:



Set the master fixture to any auto or sound mode using the buttons on the rear of the unit. Connect the slave units to the master using DMX cable. Press the menu button of the rear of the unit until the display shows: DNCO, SLAE or AUTO. Use the up and down button to set the fixture to SLAE. The fixtures should then link up and do the same thing.
cord
  2012 by Stage Ape Lighting